It make things so much quicker, I can set it up on the work bench, check everything and then take it to the drill press and then if needed I take it to my bench vise to hold it if needing cleaning up or if needing a tap or whatever. Heinrich's are great vises and was mentioned in my link above but for some reason, I keep going back to my Speedy (holds great and less knobs, lower profile).Īnother recommendation, for putting holes in small items, I usually hold them in a small 1" toolmaker vise (like Brown & Share 752) with no bolt down tangs and then clamp that to my regular drill press vise and any orientation. Having a good flat smooth DP table is very helpful, having a vise with a very flat, damage free bottom is also key so when your moving it around on your table, it's not damaging it and staying perpendicular to the drill bit. Also good for holding items without needing a vise. Best Drill Press Vise Our Top 9 Picks 1 IRWIN 4 inch Drill Press Vise 2 VIS-265.00 small drill press vise 3 Performance Tool W3902 Drill Press Vise 4. For big work or critical, then bolt down. I can position it almost anywhere on the table quickly clamp it down, quickly re-adjust it, if needed. Personally, I use two hold down vise grip style clamps mounted to my DP table that is holding my speedy vise for a lot of the time. Use this vise on your drill press for cutting keyways and doing light milling jobs. Adjustable gibs take up any slack on both top and bottom slides. I recommend a vise (whatever it may be) that it has bolt down tang slots on the sides or front & rear or both like a Heinrich. This vise features an exclusive slide bar to prevent jaws from tilting up or sideways when tightening. A vise that's hard to clamp down to your table or takes a while, will most likely be used without being clamped, Rambo style. One common thing that I think we all can at least agree on is the ease and speed of clamping down the vise in place is very important. They're several ways to skin a cat, its just matter of finding which way you like to do it? I have drawers of vises (I use to collect) including Kurt, Starrett, Brown & Sharpe, Heinrich, Palmgren, Cardinal.etc
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |